Conduit Installation - Videos and Related Books
This 62-minute video shows how to measure, cut, bend, and install conduit. It describes popular types of conduit, fittings used with Electrical Metal Tubing (EMT) and similar low-voltage conduit, and tools used when working with conduit.
The procedures shown are for conduit used with low-voltage (under 600 volts) applications in substations such as relay control circuits, drive-motor circuits, and 120-volt outlets.
Conduits and Fittings – 13 minutes
Shows five types of conduit and explains the applications for each. Describes the fittings used with conduit.
Tools – 11 minutes
Identifies basic hand tools used to cut, thread, ream, and bend conduit. Demonstrates how to use a thin-wall bender.
Installing Rigid Conduit – 11 minutes
Demonstrates how to install rigid conduit using a rigid conduit bender. Shows how to make an offset, 90-degree bends, and install fittings.
Installing Flexible Metal Conduit – 9 minutes
Shows how to cut flex conduit, use a fish tape to pull wires through rigid conduit and flex, and install fittings at each end of the run.
Installing Electrical Metallic Tubing – 11 minutes
Shows how to install EMT (thin-wall conduit) using a thin-wall bender. How to make an offset, a saddle, and install fittings and conduit straps.
Installing Liquid-Tight Flexible Metal Conduit – 7 minutes
Shows how to install conduit for a rain-tight connection between electrical appliances.