The Cable Splicer's Handbook - Ch.11 PILC Cable Splices and Terminations

$ 95.00

Summary

The Cable Splicer's HandbookTopics in chapter 11 of The Cable Splicer's Handbook are also covered on these videos.

The Cable Splicer's HandbookA set of 11 disks for chapters in the cable splicer's book is available here.

Chapter 11 - PILC Cable Splices and Terminations

    Introduction – 7 minutes
    Describes the design and construction of a single-conductor PILC cable. Identifies five types of splices made to a PILC cable, and describes a situation in which each might be used.

    Cable Preparation/Splicing PILC Cable – 9 minutes
    Identifies some of the tools and equipment used for preparing a PILC cable to be spliced. Using a splice kit and a specific set of instructions, describes how to prepare two PILC cable ends for a straight splice.

    Splicing PILC Cable – 10 minutes
    Using a splice kit and a specific set of instructions, describes how a straight splice can be made to a PILC cable.

    Transitional Splice – 9 minutes
    Using a specific set of instructions, describes how a transitional splice can be made between a single-conductor solid dielectric cable and a single-conductor PILC cable.

    Trifurcating Transitional Splice, Part 1 – 11 minutes
    Using a splice kit and a specific set of instructions, explains how to prepare for a trifurcating transitional splice between three single-conductor dielectric cables and a three-conductor PILC cable.

    Trifurcating Transitional Splice, Part 2 – 11 minutes
    Using a splice kit and a specific set of instructions, explains how a trifurcating transitional splice may be made between three single-conductor dielectric cables and a three-conductor PILC cable. 

    PILC Cable Terminations – 8 minutes
    Demonstrates one method of installing a termination on a paper-insulated lead-covered (PILC) cable.

    15 kV Class PILC Cable Preparation – 11 minutes
    Identifies the components of a PILC cable. Describes and demonstrates how to prepare a three-conductor PILC cable for termination.

    15 kV Class PILC Cable Termination – 12 minutes
    Demonstrates how to build a stress cone on a three-conductor PILC cable. Demonstrates how to attach connector stems. Demonstrates how to install and assemble a pothead onto a cable. Demonstrates how to seal a three-conductor PILC cable termination.

       

      Item Code: 517-CH11-IV